Thingiverse
Belted Extruder Optical Sensor
von KenayKustoms
5
Downloads
1
Likes
0
Makes
A small add-on to Dintid's Belted extruder "https://www.thingiverse.com/thing:1764551"
Takes a standard Optical sensor to check filament run out.
Wire routing is included in the body to keep things neat, but will require de-pining your plug to route cable.
Printed PLA 20% infill. no supports required
V1.1 - short
v2.2 - Taller and m6 bowden
Takes a standard Optical sensor to check filament run out.
Wire routing is included in the body to keep things neat, but will require de-pining your plug to route cable.
Printed PLA 20% infill. no supports required
V1.1 - short
v2.2 - Taller and m6 bowden
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!