Thingiverse
bench vice width 90 mm
von bandit-ed
178
Downloads
116
Likes
0
Makes
this is my first printed version in PLA but i think i will make a other one with ABS
there are 2 bars/tubes of 12 mm inserted for guiding the jaw
the m12 threaded rod is inserted in the bushing (m12 thread) then drilled through with 6.5 mm
there are 2 bars/tubes of 12 mm inserted for guiding the jaw
the m12 threaded rod is inserted in the bushing (m12 thread) then drilled through with 6.5 mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
