Benchy Under-shelf Rack

A simple under-shelf display rack for your benchies. The spacing between the benchies is such that you can turn them to about 45 degrees to show them off better than if straight on.

The orientation is correct in my slicer, Superslicer, but in case it differs in other slicers, have the front edge of the rack on the build plate.

I have an Ender 3 V2 and this was the longest rack I can print. I’ve also included a couple of shorter versions, which I used to complete the full length of a couple of shelves.

Originally I used strong double-sided tape and simply stuck these under the shelves. However, they came down a couple of times, though they lasted a few days, so I redesigned them so they can be screwed in place. I’ve included both versions (“sticky” and “screws”) as you might have better tape than I had.

Can probably be printed in anything (I used PLA+) and 20% infill makes them more than strong enough. No supports required.

Though I made this myself it’s a sort of remix