Thingiverse
Bender Tool for electronic components
von 1010011011user
1.6k
Downloads
912
Likes
22
Makes
Bender Tool for electronic components
This is a Remix of http://www.thingiverse.com/thing:1022337
The tool is now less likely to cause injuries and can bend Beside axial components, transistors / MOSFETS / (non axial) condensators / LEDs and any other thing that fits the slot. The axial component slots are given a small fillet,
The MOSFET slot has a chamfer & fillet so also components with a thinner wire can be bend to the desired angle. The obstruction in the middle is small enough, for TO-220 and both slots are wide enough for TO-92.
The Remix of the source file is included. The Remix Update is less high reducing print time and has a hole in it for easy use (nail not included).
Guidelines:
http://www.ipc.org/committee/drafts/1-13_d_7251WD1.pdf
The NON-COMMERCIAL license is not applicable to Robert Smith https://eatyourguitar.myshopify.com/ I checked out his site and understand the service he want to give to his select group of customers. Provided the will add a Q
This is a Remix of http://www.thingiverse.com/thing:1022337
The tool is now less likely to cause injuries and can bend Beside axial components, transistors / MOSFETS / (non axial) condensators / LEDs and any other thing that fits the slot. The axial component slots are given a small fillet,
The MOSFET slot has a chamfer & fillet so also components with a thinner wire can be bend to the desired angle. The obstruction in the middle is small enough, for TO-220 and both slots are wide enough for TO-92.
The Remix of the source file is included. The Remix Update is less high reducing print time and has a hole in it for easy use (nail not included).
Guidelines:
http://www.ipc.org/committee/drafts/1-13_d_7251WD1.pdf
The NON-COMMERCIAL license is not applicable to Robert Smith https://eatyourguitar.myshopify.com/ I checked out his site and understand the service he want to give to his select group of customers. Provided the will add a Q
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
