MakerWorld
Office
Go to Model
BenQ ScreenBar stand-off riser - AW3821DW
36
Downloads
9
Likes
22
Makes
This print is designed to support the BenQ ScreenBar on top of the Alienware AW3821DW ultrawide monitor.Due to the deptcxh at the center of the monitor's bezel, the ScreenBar does not sit flush; meaning the light tends to shine on the screen itself. There are similar solutions out there I found, however they show the ScreenBar set back from the monitor bezels edge, so while the light bar is more secure, you get the same problem of it shining on the curved screen.This design locates the ledge of the Screenbar where you would expect it over the edge of the bezel, just supported higher up to accommodate the depth reduction. The ScreenBar and counterweight now sit flush and comfortably with no movement. This design may work on other monitor models however I have not tested.The photographed example is printed with grey Bambu Matte PLA on an A1 printer.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!