BentoBox Cable Guide Clip

BentoBox Cable Guide ClipIt allows you to organise and easily clip the cable in place for the BentoBox; it can also be just as easily unclipped and moved out of the way when not needed.This clip is compatible with P1P/P1S/X1C.I can only recommend the profiles I created (“Designer” print profile) for the best results.Print using a filament that can withstand high temperatures (NOT PLA!), I used ABS, however, PETG should work just fine.The channel width is 5 mm, you do not need a low gauge (thick) cable for this (the fans consume around 1.5W).You can use any connector you prefer inside the BentoBox, i'm using these 2-pin JST connectors: https://a.aliexpress.com/_ExVDHVB 1. Importing:Import the 3MF file into the slicer and make sure the selected settings are correct (video below). I have already set the correct settings for the 3MF file, but it is a good practice to verify, and you still have to select your printer if it's not a P1S. 2. Post-processing: Pull apart the brim and the small s