Beolab 3 - Wall mount

This is a printable wall mount for B&O - Beolab 3 speakers. It is a two-piece design, where you mount the first piece on the wall, and afterwards slide the second part down.

Remember to route cables through the first piece before securing to the wall. Be careful not to damage the cables while sliding the second piece on. There is a cable channel in the second sliding part, gently pull the cables out while sliding down. Cables must be routed through the hole before sliding down.

For perfect fitment, print small scale of both pieces, and scale according to your printer tolerances. The two pieces should be sliding freely when not mounted on the wall. If your wall is very uneven, print and scale to a loose fitment. Because of the sliding design, the wall must be relatively straight, and be without large bumps and voids.

Printed with 3-4 perimeters and 35% infill and support ON
Printed in same orientation as mounted on the wall, both pieces.

UPDATE: V2
• Added 45deg chamfer