Beta 2 - AMS Ultimate Drying System

**** The Final Release version is here Ultimate Automated AMS Filament Dryer by Peter Barclay - MakerWorld **** This is designed to be a Filament Drying System for your AMS. Desiccants will remove unwanted humidity from the air in the AMS, a Dryer like this one is designed to remove moisture from the filament and then expel it from the AMS. Parts Needed14 - M3x5mm - These are to attach the 3 model parts to each other2 - M4x5 - These are to attach a PTC Heater to the Heater Mount2 - M3x20 - These are to be hinge pins that will protrude and work with the hinge receiver blocks in the AMS. To remove the AMS Lid and reattach this new lid, please see the AMS instructions herehttps://wiki.bambulab.com/en/x1/maintenance/replace-ams-bottom-cover#step-5-removing-the-ams-upper-cover The PTC Heater I purchased and used is a 200watt with 60mm fan that runs on 110vhttps://www.amazon.com/dp/B0BTLMNFB1 The Digital Temperature Controller I used has Fahrenheit, there are cheaper ones that only use Celci