Thingiverse
Beta Motorcycle 2 Stroke MAP Switch Relocate
by megclay
0
Downloads
1
Likes
0
Makes
Beta 2 Stroke MAP Switch Relocate (use PETG, PCTG or stronger plastic)
Its made so no screws are needed to hold the switch in (my switch the screw holes were stripped) but you can also screw it in
Made a frame mount in two parts or three and epoxy together
both use #6x1" screws with lock nuts
Made a bar mount for 7/8" bars
one set (cyan color) is made for 3x18mm or 20mm screws and 3mm rev-nut pressed and glued in
other set (green color) is made for #4 x 3/4" wood screws (or any other screw just drill out to diameter needed)
Its made so no screws are needed to hold the switch in (my switch the screw holes were stripped) but you can also screw it in
Made a frame mount in two parts or three and epoxy together
both use #6x1" screws with lock nuts
Made a bar mount for 7/8" bars
one set (cyan color) is made for 3x18mm or 20mm screws and 3mm rev-nut pressed and glued in
other set (green color) is made for #4 x 3/4" wood screws (or any other screw just drill out to diameter needed)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!