Thingiverse
BETA85X SWIFT
von Empyrion
4
Downloads
3
Likes
0
Makes
REVISED - increased clearance around the back of the camera for the connector and tweaked a few of the other dimensions. I will print it in a day or two and check and revise again if necessary.
I wanted to replace the caddx EOS2 as i had scratched the plastic lens. I designed it to fit the micro swift, as i had a spare uart and the camera is ready for camera control from the FC
Camera is set to 25° for now,
Remix if you want.
This is the first thing i have designed in fusion360, and will most probably change once i have finished printing it.
I wanted to replace the caddx EOS2 as i had scratched the plastic lens. I designed it to fit the micro swift, as i had a spare uart and the camera is ready for camera control from the FC
Camera is set to 25° for now,
Remix if you want.
This is the first thing i have designed in fusion360, and will most probably change once i have finished printing it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!