Thingiverse
Beta95x v3 Gopro mount
von guernicafpv
5
Downloads
0
Likes
0
Makes
Designed to be usen in the Beta95x V3 drone, to carry the full gopro in the top plate. it need to be pushed into the battery strap holders.
The Lipo-strap was holding by the Gopro mount.
I make it in PLA 100% infill at 0.12 profile.
Not support needed.
In the bottom part of this adapter, you can stick 3M double-sided adhesive tape.
The Lipo-strap was holding by the Gopro mount.
I make it in PLA 100% infill at 0.12 profile.
Not support needed.
In the bottom part of this adapter, you can stick 3M double-sided adhesive tape.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
