Bevel Gears

I needed some gears, https://youtu.be/Rld1ZAs6YxA shows them running. Seem to fit reasonably well. Included the OpenScad file with settings from GregFrost's thing.

Printed at .2mm layer height, 10% infill (final one I'll do thicker). One axis is designed for a 30mm hex shaft. The other is a 6mm shaft from something like a 37D motor.

The motor gear has a 3mm set screw hole that would need tapped to use.

There are two different sets: 13:43 and 15:37, I'm not sure what gear ratio I'll need for BB-8 :)

The shaft of the little gear printed a tad too small, but I expect you guys to adjust the fittings to fit your project.

These are intended for my [Lego BB-8](http://LegoBB8.com) flywheel drive, we'll see how that goes.