Slicer Discord
Beyerdynamic MM1 Ground Plane Measuring Base – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Beyerdynamic MM1 Ground Plane Measuring Base

6 Downloads
1 Likes
1 Makes
Zum Modell
This is a microphone base I did for the Beyerdynamic MM1 measuring microphone to do Ground Plane Measurements. Usually the microphone sits completely on the floor, and due to the larger diameter size near the connector, it sits slightly higher than it could be, if you put tape on it sometimes it moves from the position. With this base you could put the diaphragm much much closer to the ground and in theory you could measure higher up without artefacts. It has two different sizes, for MM1 you need the short one. It needs a m5 nut, m5 washer and a 1 inch 3/8 hex screw. Boost Me
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen