Thingiverse
Bezel, Display and Keypad
von joelisa03
0
Downloads
1
Likes
0
Makes
*** If you use this design and it works well for you, please consider $1 Tip to the Designer. It's only a buck to help support the creations. Thanks in advance! ***
I needed a single panel to house a 4x4 keypad and 20x4 LCD display. I wanted something that would recess the keypad enough to allow a single overlay to be placed on the entire panel, with custom graphics over the keypad. The 20x4 LCD display also needed to be mounted from the back of the panel.
This bad boy does a great job! Just large enough to make things manageable, but not too big for most 3D printers.
Enjoy!
I needed a single panel to house a 4x4 keypad and 20x4 LCD display. I wanted something that would recess the keypad enough to allow a single overlay to be placed on the entire panel, with custom graphics over the keypad. The 20x4 LCD display also needed to be mounted from the back of the panel.
This bad boy does a great job! Just large enough to make things manageable, but not too big for most 3D printers.
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!