Slicer Discord
Bezel for 0.91" OLED 128x32 Module – Modelo 3D imprimible de Thingiverse Thingiverse

Bezel for 0.91" OLED 128x32 Module

por peaberry
5 Descargas
10 Likes
0 Makes
Ver Modelo
This is a simple bezel which can be used to mount a 0.91" OLED 128x32 display module on a panel. It's intended to be used with two M3 screws direct into the plastic through the panel from the rear. The mounting holes are 46mm apart and 4mm deep. The overall size is 54x20x5mm. Note that the OLED is not symmetrical, so it only fits the opening in one orientation (should be obvious when you try it).

The part I used was described as "I2C OLED Display Module I2C Screen Tiny Module 0.91 Inch Blue 128X32 DC 3.3V to 5V"
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

peaberry también publica en

7 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

4 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección