Thingiverse
BFB Conversion Spool and End Stop Switch Holder
por drfrog
2
Descargas
2
Likes
0
Makes
Bits From Bytes Conversion
End Stop micro switch holder. The center id is 12 mm the micro switch is 12.5 mm center pin to pin. This was a micro switch holder that attaches to the 12 mm rods that connect the X, Y axis. Conversion to Ramps 1.4 Board while still using the magnetic internal sensors to the machine as well for end stops.
Filament reel holder for BFB or any printer. Special note this is a large print job.
End Stop micro switch holder. The center id is 12 mm the micro switch is 12.5 mm center pin to pin. This was a micro switch holder that attaches to the 12 mm rods that connect the X, Y axis. Conversion to Ramps 1.4 Board while still using the magnetic internal sensors to the machine as well for end stops.
Filament reel holder for BFB or any printer. Special note this is a large print job.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!