BFPTouch for Klipper

So I was able to get the BFPTouch to do all the standard functions of other bed levelers (home, bed level, etc.) in Klipper. See attached for the full document.


############ BFP Touch config ###################
### Bryon Wheeler 11/18/2024 ###
# It's cheaper, easy and I think more accurate than the BLTouch
## https://www.thingiverse.com/thing:2890290

[stepper_z]
step_pin: PB0
dir_pin: PC5
enable_pin: !PB1
microsteps: 16
rotation_distance: 8
endstop_pin: probe:z_virtual_endstop #use probe as Z endstop
position_max: 375
position_min: -2

[servo BFPTouch]
pin: PA1 #Set to your servo for the probe arm
initial_angle: 0
maximum_servo_angle = 93 #set you max angle (probe out), find via SET_SERVO SERVO=BFPTouch ANGLE=93
minimum_pulse_width = 0.001
maximum_pulse_width = 0.002

[bltouch]
sensor_pin: ^PC2 #Set to the pin activated by the optical sensor
control_pin: PA2 #pick an unused one, we aren't using it but it is required
#tap the head to painters tape on the