MakerWorld
Decor
Go to Model
Biblioluminescence
6
Downloads
9
Likes
0
Makes
This is my bookshelf light, it took me a good while to get it to where it is now. The current design is using the following now printed parts: BOM: 1* 608zz Bearing 48* 8x3 Magnets 1* 1m LED Warm White Strip, 8mm width. 1* 4AA Battery Case 6V 1* Lever Micro Limit Switch Obviously, this contains a heck of a lot more magnets than it needs, and in future iterations I will change some of these magnets to be push fits, maybe with a dab of glue. For now I wanted to push the limits as to what I could design, so went a little far on the magnets. Roadmap: Wait for electronics to arrive Install all magnets, electronics Test Upload real images Improve print profiles for everyone Remove bearing and just have it fit on a printed spindle Remove some magnets and make it push fit, except for the top panel If anyone has personal needs in this, or ways I can improve, please send me a message and I'll look into it. Happy printing!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
