Slicer Discord
Bibo 2 BLTouch mount – Modelo 3D imprimible de Thingiverse Thingiverse

Bibo 2 BLTouch mount

por 2hot6ft2
5 Descargas
3 Likes
0 Makes
Ver Modelo
Used the part that the BLTouch mounts to and changed it to mount on the side of the carriage instead of in front.
It mounts using the 2 bolts for the linear bearings carriage.
I used 40mm bolts for my setup YMMV

There are 2 versions.
BiboBLTouch.stl has a 1mm deep notch which I needed for it to fit with the blue cover seen in the pictures

BiboBLTouchNoCutout.stl is like the name implies without the notches

They are the same height otherwise.
For me this put my offset at about X-73, Y0 since it is close if not right in line with the extruders on the Y axis. This may not be precise but it's close enough for me.


Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección