Thingiverse
Bibo Rear Bracket
por Topcat_Ern
0
Descargas
2
Likes
0
Makes
Easily broken bracket holding on the filament out sensor on the rear of the Bibo. Couldn't find a replacement so thought that I'd better make one. Printed in resin as I thought it may be more durable than filament.
The design is not handed so can replace either left or right.
The only change that I made to the original design is using a 16mm or 20 mm M3 bolt instead of the standard shorter one as it would 'bite deeper' where it attaches to the top bracket and not break so easily. Sensor bolts are fine to re-use.
The design is not handed so can replace either left or right.
The only change that I made to the original design is using a 16mm or 20 mm M3 bolt instead of the standard shorter one as it would 'bite deeper' where it attaches to the top bracket and not break so easily. Sensor bolts are fine to re-use.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!