Thingiverse
Bicycle flashlight holder mount
von mato4mato
7
Downloads
12
Likes
0
Makes
holder for 22mm thick tube and light with 25mm diameter
for assembly:
2x M3x20mm long screws
4x M3x10 to 12mm (with nuts)
4x nuts M3
glue to connect two rings with rectangle platforms for it.
Make sure to set X angle for your bike (perpendicular +- 4degrees based on your bike) before glueing, otherwise it will shine a bit sideways
0.15 layer height
I used 0.4mm extruder, 3mm brim and support
printing time around 2h
13g with supports and brims
for assembly:
2x M3x20mm long screws
4x M3x10 to 12mm (with nuts)
4x nuts M3
glue to connect two rings with rectangle platforms for it.
Make sure to set X angle for your bike (perpendicular +- 4degrees based on your bike) before glueing, otherwise it will shine a bit sideways
0.15 layer height
I used 0.4mm extruder, 3mm brim and support
printing time around 2h
13g with supports and brims
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
