Bicycle Handlebar Stand

Bicycle handlebar stand inspired by this design https://www.thingiverse.com/thing:4869945 which I had to reshape a little to my tastes

It's a sturdy design and will take time to print. At this time I have no advice on the printer settings, but a printing expert should be able to figure them out for one's own printer.

NOTE: this is a single side shape and you need to print two copies of that, then you connect these with an M10 bolt (length 70mm should do) and preferably nyloc nut, use of washers on both ends highly recommendable.

Of course to use the stand aspect effectively, you need to print four of these shapes and connect them in pairs to have stands on both ends of the handlebar to elevate the bar from the floor when working on a "belly up" bike.