Thingiverse
Bicycle SPD Cleat Adjust Tool
by bazza_light
34
Downloads
23
Likes
0
Makes
Design is intended to allow more repeatable accurate adjustments of SPD (MTB) shoe cleats.
Not necessary but embossed text looks better if you do a colour change at 0.8mm Z height (and a change back at about 1.4mm) .
Appreciate feedback / suggestions to improve.
Length of the tool was largely determined by my print plate and my size 43 shoe :)
Picture version has been slightly updated to better radius the toe end of the tool.
There are plenty of You_tubes on cleat adjustment to give options on best setup.
Not necessary but embossed text looks better if you do a colour change at 0.8mm Z height (and a change back at about 1.4mm) .
Appreciate feedback / suggestions to improve.
Length of the tool was largely determined by my print plate and my size 43 shoe :)
Picture version has been slightly updated to better radius the toe end of the tool.
There are plenty of You_tubes on cleat adjustment to give options on best setup.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
