Thingiverse
Bicycle Wheel Trueing Device
door zandoval
13
Downloads
6
Likes
0
Makes
The device is used to hold two sections of Coat Hanger Wire in position to true a rear bicycle wheel. You attach the device using simple Rubber Bands on the Seat Tube then turn the Coat Hanger Wires in to rub against the rim for adjustment truing. I use heavy gauge Coat Hanger Wire at 2.6mm diameter so the holes are 2.7mm in diameter. Device was printed on an Ender3 using Ideamaker as its slicer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
