Thingiverse
BIDEN HARRIS KEYCHAIN
5
Downloads
10
Likes
0
Makes
Joe Biden was announced president elect so I designed this keychain.
A simple filament switch will make the words a little more visible.
This is a great gift or way to show your support.
Its 3mm thick and the words are 1 mm tall. The hole for the keychain is 5mm, plenty for any keychain. Length and width 20mm x 50mm. These were sliced at 25% infill and .1 layer height so they took about an hour each. They were printed on my ender 3 so you can see the N and E are squiggly but thats just my printer.
A simple filament switch will make the words a little more visible.
This is a great gift or way to show your support.
Its 3mm thick and the words are 1 mm tall. The hole for the keychain is 5mm, plenty for any keychain. Length and width 20mm x 50mm. These were sliced at 25% infill and .1 layer height so they took about an hour each. They were printed on my ender 3 so you can see the N and E are squiggly but thats just my printer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
