Thingiverse
Biesse Rover vacuum pod
von RafiDXF
1
Downloads
1
Likes
0
Makes
3D model of vacuum pod for Biesse CNC (in my case Rover a3.30)
Valve and angle adjusting ring should be replaced with the old pads (whole fits the same scrues).
For this design, i use EPDM6x8 seal (CMT product)
The outer cavities are left for anti-slip rubber. I use K+D (WURTH) and then mill to remove the excess.
Valve and angle adjusting ring should be replaced with the old pads (whole fits the same scrues).
For this design, i use EPDM6x8 seal (CMT product)
The outer cavities are left for anti-slip rubber. I use K+D (WURTH) and then mill to remove the excess.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!