Big Ass Brick Holder

This is just a simple soap holder for the Duke Cannon Big Ass Bricks. It helps let your Bricks last much longer as the bottom doesn't get soft and wash away.
I didn't use support when I printed mine except for on the very edges of the model, any layer height should be fine, I used .28, but I'm sure .32 and higher would be fine on printers that allow it, and finer of course.

Print the file with the top facing the build plate, either use full support or do as I did and add a support blocker on everywhere except for the far left and right of the model.

Or print it whatever way work best for you of course, I'm not your dad.