Thingiverse
Big Ben Clamp
by IraB
6
Downloads
4
Likes
0
Makes
Big Ben Clamp for 48 - 51mm Tubes
Parts List:
1x M12 Swing Bolt - 70mm Long
1x M12 Wing Nut
1x M12 Nut
1x M12 Washer
2x M10 Slotted Spring Pins - 50mm Long
I have yet to print this so unsure of the infill settings ect. but planning too very soon.
I will be using this for a Camera Dolly Slider and I reccomend you give it a go too as a fun project.
*BIG DISCLAMER. DO NOT USE TO SUSPEND HEAVY OBJECTS FROM IT. This is solely for small loads like being used for camera sliders and so on. If you use this for anything heavy you are putting yourself and others in danger*
Parts List:
1x M12 Swing Bolt - 70mm Long
1x M12 Wing Nut
1x M12 Nut
1x M12 Washer
2x M10 Slotted Spring Pins - 50mm Long
I have yet to print this so unsure of the infill settings ect. but planning too very soon.
I will be using this for a Camera Dolly Slider and I reccomend you give it a go too as a fun project.
*BIG DISCLAMER. DO NOT USE TO SUSPEND HEAVY OBJECTS FROM IT. This is solely for small loads like being used for camera sliders and so on. If you use this for anything heavy you are putting yourself and others in danger*
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!