Big Box Microsoft Lifecam Mount

I already had too many Raspberry Pi's lying around my house so I didn't opt into the OctoPi upgrade when I got my BigBox. This however left me without a camera. I had an old Microsoft Lifecam that I wasn't using so using the existing camera mounts on the front of the big box I designed this mount.

There is a 10 degree angle to help point the camera towords the bed but the camerea still can move up and down and side to side.

Currently I just have the cable going through the access hole in the below the bed, but I will eventually cut some holes to run it down the front-right of the printer to the RPi