Big Brick * Baseball

5/2026: NEW PRINT PROFILE WITH INCREASED SUPPORTS - V2 A few people mentioned that they had some issues with the supports falling off halfway through this multi-color print which is frustrating and wastes a lot of time and money. I increased the supports and changed them from tree to normal supports so there is less of a chance of support failure. The supports still remove easily. As with version one, there is still a lot of filament waste because of the multiple color changes. Make sure you have enough filament before you print! This is a Baseball accessory for baseball-related Big Brick Figures. Handle should fit most Big Bricks (approx 6:1, 500%) on Maker World, but make sure to check sizing prior to printing. Handle diameter is ~16.5 mm. AMS is required. Be prepared - this baseball creates A LOT of filament poop (see photo - I printed 4 baseballs at one time). There is some minor bleeding because of the red on white as well. Minor support is needed for the baseball's bottom. I made