Big Brick * Basketball

This is a basketball accessory for Big Brick Figures. It contains a handle for the Big Brick figure to hold - approximately 16.5 mm wide in diameter. It was inspired by Jandaa's football model: https://makerworld.com/en/models/488293#profileId-401200 NEW UPDATE 4/2025: Added a new print profile! I made a separate handle so you can print it separately and screw it on and off. A support blocker was placed on the screws parts/threads. You may get stringing due to this, but just screw in the handle and it'll take those away. You may need to clean up the threads a bit if the screw handle doesn't engage. Printed at 7% Lightning which works fine, but if you want more durability, I would do at least 10% and your infill of choice. Made it screw on and off so it is interchangeable with my BASEBALL version. AMS is required. Be prepared - this basketball creates A LOT of filament poop. There is some minor bleeding because of the black as well. I tried to make it hollow to reduce the poop and print