Thingiverse
Big C Crystal modular
door SquidCap
31
Downloads
20
Likes
0
Makes
A modular remake from Big Clive's Crystal.
The spikes/crystals are printed in vase mode, with 4 bottom layers. 1.5h print time at 50mm/s and 0.2mm layer height. They can be scaled in Z axis to be taller or shorter.
The base is difficult to print, it should be printed upside down to prevent using supports but it's angle is well over what is recommended. I managed to do it by printing innerwalls first but it wasn't fully success. Had to support it once with tape, luckily a lot is covered byt the crystals and in clear filament it is hard to notice such flaws. I used 0.2mm layer height, probably it should be printed with 0.12mm. Printing the base takes about 3.5h at 0.2mm and 50mm/s if you can do it without supports.
If you decide to scale it in XY, you have to think about the led holes, they are now 5.5mm diameter.
For wiring diagram (i have no affiliation with the channel): https://www.youtube.com/watch?v=orOaQHuhr2g&t=560s
My version uses slow color changing RBG LEDs, ma
The spikes/crystals are printed in vase mode, with 4 bottom layers. 1.5h print time at 50mm/s and 0.2mm layer height. They can be scaled in Z axis to be taller or shorter.
The base is difficult to print, it should be printed upside down to prevent using supports but it's angle is well over what is recommended. I managed to do it by printing innerwalls first but it wasn't fully success. Had to support it once with tape, luckily a lot is covered byt the crystals and in clear filament it is hard to notice such flaws. I used 0.2mm layer height, probably it should be printed with 0.12mm. Printing the base takes about 3.5h at 0.2mm and 50mm/s if you can do it without supports.
If you decide to scale it in XY, you have to think about the led holes, they are now 5.5mm diameter.
For wiring diagram (i have no affiliation with the channel): https://www.youtube.com/watch?v=orOaQHuhr2g&t=560s
My version uses slow color changing RBG LEDs, ma
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!