MakerWorld
Vehicles
Voir le modèle
Big John Plate trailer
0
Téléchargements
0
Likes
0
Makes
My Parents saved my old BIG John Track, but they lost the trailer. My son get it and was a bit disappointed because of the missing trailer. What else … I designed a replacement, that can fit a Bucket or can be used as stand alone. It has 3 holes where water can be drained. The Pinch is a bit copied from the orginal. I had a bit left over inside the suspension. And that way it doesn't need support It has an outer diameter of 220mm a thickness of 2,7mm that way its stable enough.Printed in PETG because its outside and has to be a bit harder then PLA.With SunLu Red PETG it took in my p1s round about 4:42h and two plates. Its the standard sunlu PETG preset at 0.2mm, 2 Walls … Assemblies is pretty easy. Aline the cross from the plate with the hole in the Big John suspension. Put the pinch inside and push until the bigger round part of the pinch enters the first suspension point. To remove just pull it out or pinch something from the other side against the pinch.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !