Big Vault Combination Safe

Here is the big one, the big vault. You will need an H series sized printer or larger or break into smaller pieces. I am working on a version that will fit the smaller printers. Make sure your bed is very clean and glued and your filament is calibrated and dry. These large prints try to pull up at the edges so good practices are needed. Print the door first and make sure you can get things working before printing the main body. This with prevent possible wasted time and filament. Assembly Step 1: Glue the alignment ring to the door with super glue. Then glue the number indicator to the door making sure to keep things lined up and pressed together well. Step 2: Set your code wheels. there are three “driven code wheels” and 1 “drive wheel” as well as 4 “code pins” that snap into each code wheel. When picking a code there are a few limitations. 1 avoid the first six notches shown on wheel 3 2. two adjacent wheels cannot have a code pin in the same hole. For the driven wheel I recommend pl