Thingiverse
Bigshock Rail
door Hitokiri_Fox
8
Downloads
8
Likes
0
Makes
Original rail fit was really good, I just felt it sat a bit high. Remixed the rail so the bottom is flush with the top of the Bigshock. Also went a bit farther and made a 3dot sight version as well as a 3dot fiber version.
*Note for fiber version - It has a small hole to insert 1.75mm pla into it and trim to act as a pseudo fiber optic sight. It is a preliminary design but did work on my first attempt, though i might find a small drill bit that is the same size and make sure the hole is cleaned up as it was a little tough getting the filament in.
All variations printed on their nose with supports and a raft.
*Note for fiber version - It has a small hole to insert 1.75mm pla into it and trim to act as a pseudo fiber optic sight. It is a preliminary design but did work on my first attempt, though i might find a small drill bit that is the same size and make sure the hole is cleaned up as it was a little tough getting the filament in.
All variations printed on their nose with supports and a raft.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
