Bigtendo

Hi!

This is my second arcade controller case.

If you love retrogaming this one will make you happy. I scaled by 3 the measurements of the classic SNES controller and the result is a huge and nice arcade controller.

Side buttons (L & R) works great, and the select+start buttons are a bit loose but works ok too.

I bought the controller kit from ebay )http://www.ebay.es/itm/252687032631 ). Includes a Sanwa JLF joystick, 9 buttons (28mms) ,two 17mm small buttons and the usb cable+board. There's a lot of kits from many sellers, just take care of the model of joystick and the buttons.
You may need 6 full buttons and the switches from other 2 buttons (used for select and start)

Biggest part is 184x169x70 mms so any standard 200x200 printer can manage well.

No supports needed Some parts have a sort of support that you can remove once printed,

Some instructions and tips:

Middle part has 3 variants: One with a hole for a 17mms button (used as hotkey in Recalbox/Retrop