Bike holder

Before assembly is necessary to make a thread of the body hole for a 5mm flat head screw, 20mm or less long.
Also procure a 30mm wide and approximately 25mm long (depends how strong is it) spring.

My advice is apply a rubber layer (I cut a piece of an old bike inner tube, for example) under the Body1, where it is in contact with handlebar or whatever.

Fasten with two cable ties following the guide in the Body1.




PRINT SETTINGS:

-Lock1 & Lockfemmina:

-support pattern: line
-support wall line count: 1
-support density: 10%
-enable support roof and floor
-support roof thickness: 0.8 mm
- floor : 0.5 mm
-minimun support area: 2 mm^2
-m