Thingiverse
Bike Light Locks
door luispiek
0
Downloads
0
Likes
0
Makes
Got tired of my bike lights being stolen off my handlebars, so decided to print up some easy locks for the Akale Rechargeable Bike Lights on Amazon (https://www.amazon.com/dp/B0CMDGG12X). Need to add a small bit of rubber (no more than 20cm long) of rubber, drill an extra hole in the light body, and use small set screws to mount. Works well and can still access the charging ports on the lights. So far so good, I still have my lights!
Step 1: Disassemble lights, remove the clip on the back of the light body
Step 2: Drill out holes in the light body top and bottom with a 3mm bit
Step 3: Cut a ~20mm long strip of thin rubber for front light clips
Step 4: Mount backs of light body to printed parts using small ~12mm long screws
Step 5: Reassemble lights onto bicycle
Step 1: Disassemble lights, remove the clip on the back of the light body
Step 2: Drill out holes in the light body top and bottom with a 3mm bit
Step 3: Cut a ~20mm long strip of thin rubber for front light clips
Step 4: Mount backs of light body to printed parts using small ~12mm long screws
Step 5: Reassemble lights onto bicycle
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
