Slicer Discord
bike light – 3D-Druckmodell von Thingiverse Thingiverse

bike light

0 Downloads
0 Likes
0 Makes
Zum Modell
Фонарь не имеет влагозащиту! Не предусматривалась!
Светодиод использовал 3 ваттный - https://www.chipdip.ru/product/tds-p003l4o10.
Понижающий DC-DC xl4015e - https://aliexpress.ru/item/1005001636420985.html?spm=a2g2w.orderdetail.0.0.35994aa62jPIjj&sku_id=12000016918460848.
Выключатель T120.
Крепление на руль сделано из крепления для ПП труб 21мм
В петлях куда прикручивается верхняя пластина есть места под установку гаек (с обратной стороны).
Светодиод прикручен через большие гайки.


The lantern has no moisture protection! Not provided for!
The LED used 3 watts - https://www.chipdip.ru/product/tds-p003l4o10.
Step-down DC-DC XL4015E - https://aliexpress.ru/item/1005001636420985.html?spm=a2g2w.orderdetail.0.0.35994aa62jPIjj&sku_id=12000016918460848.
Switch T120.
The handlebar mount is made of a 21mm polypropylene pipe mount
In the hinges where the upper plate is screwed, there are places for installing nuts (on the reverse side).The LED is screwed through large nuts.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen