MakerWorld
Sport & Outdoors
Go to Model
Bike Pump Mounting Bracket
25
Downloads
11
Likes
11
Makes
Mounting bracket for a 25mm diameter bicycle tire pump. To insert or remove the pump you must extend its handle and pass that through the gap. The original model did not include a pump holder. Known flaws:Gap is too small (2mm). Ideally it would be 5mm.
MCH170 also publishes on
13 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
