Bikini Canopy for Sonicmodell Binary 1200

I designed this canopy to allow the use of a split-type camera and pan/tilt mechanism. In the picture, I'm using the excellent Runcam Hybrid 4k pan/tilt by bonafidepirate. (Get it here: https://www.thingiverse.com/thing:3937599 ) The canopy is designed to be affixed with a couple of servo screws and a strip of tape where the canopy meets the fuselage. The thinner 2.0 version weighs only 15 grams.

There are now two versions:

1.0: 1mm thickness
2.0: .75mm thickness with reinforced screw pads

I've printed mine with PETG. Print with the "back" to the print bed, with front of the canopy pointing up. Supports are needed for the screw pads and optionally for the recessed nose. Getting a smooth print was tricky. The best approach seems to be printing with 0% infill and disabling "gap fill" in the slicer. Basically, print with perimeters only. If your slicer supports it, (I use Prusa Slicer) you can adjust settings for the screw pads separately, using 100% infill to make them solid, a