Thingiverse
(BILLY) Bookcase Spoolholder
by markvanson
20
Downloads
12
Likes
0
Makes
A simple filament holder utilizing the existing bookshelf support holes found on the IKEA Billy bookcase.
The slits are just tight enough to accept M3 x 15 mm bolts, this ensures no modifications are needed on the bookcase as the bolts sink into the existing holes in the side panels of the bookcase.
Can be printed without rafts, brims, or supports.
Some relevant dimensions;
Axle diameter: 35 mm
Minimum diameter spool (internal): 45 mm
Maximum with spool (axial): 80 mm
Maximum outer diameter of the spool: 260 mm
The width of the clamp on the sidewall of the bookcase is 19 mm.
Have fun!
The slits are just tight enough to accept M3 x 15 mm bolts, this ensures no modifications are needed on the bookcase as the bolts sink into the existing holes in the side panels of the bookcase.
Can be printed without rafts, brims, or supports.
Some relevant dimensions;
Axle diameter: 35 mm
Minimum diameter spool (internal): 45 mm
Maximum with spool (axial): 80 mm
Maximum outer diameter of the spool: 260 mm
The width of the clamp on the sidewall of the bookcase is 19 mm.
Have fun!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
