Thingiverse
Binary FPV Pan Tilt Mount
von Aaron5
6
Downloads
1
Likes
0
Makes
I wanted a camera mount that held the micro eagle securely without risk of dropping it
You will need:
2x 9g servers
2x M3 8mm
1x paper clip
1x runcam eagle or similar M12 camera lens with 3mm of clearance for the braket
some hot glue
Hot glue the servo arm to the bottom of the mount.
It doesnt hurt to hot glue the cam to the braket a little if you are worried it will wobble too much
You will need:
2x 9g servers
2x M3 8mm
1x paper clip
1x runcam eagle or similar M12 camera lens with 3mm of clearance for the braket
some hot glue
Hot glue the servo arm to the bottom of the mount.
It doesnt hurt to hot glue the cam to the braket a little if you are worried it will wobble too much
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
