Thingiverse
BIQU B1 filament break module stand
door bluelemonband
61
Downloads
31
Likes
0
Makes
03.11.2020 - added new file version - sensor_stand_v1 with little improvement of the design
I changed the extruder and filament break module did not fit in place. Designed this stand and now I can fit the module. For the installation I used the bolts with which the module was mounted. I need two extra nuts and two extra bolts that I took from the old extruder. You need to mount it under the frame (see the picture). Enjoy!
P.S. You may need filament guide to prevent wear of sensor body. My filament spool is on the ball bearings at the bottom next to the printer and all is OK.
I changed the extruder and filament break module did not fit in place. Designed this stand and now I can fit the module. For the installation I used the bolts with which the module was mounted. I need two extra nuts and two extra bolts that I took from the old extruder. You need to mount it under the frame (see the picture). Enjoy!
P.S. You may need filament guide to prevent wear of sensor body. My filament spool is on the ball bearings at the bottom next to the printer and all is OK.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!