Thingiverse
BIQU H2 Microprobe mount
door looxonline
23
Downloads
28
Likes
0
Makes
This is a mount to secure the BIQU microprobe to the H2 on the left side using the fan holes.
Remove one of the fan bolts and use it to secure the mount on one side. On the other side you will need to insert an M3 bolt and secure it using an M3 nut on the inner side of the fan. It is tight but doable.
Print with supports enabled touching the plate only. They break away easily.
No need to make the print super strong but since it is so small you can do four walls because why not.
Remove one of the fan bolts and use it to secure the mount on one side. On the other side you will need to insert an M3 bolt and secure it using an M3 nut on the inner side of the fan. It is tight but doable.
Print with supports enabled touching the plate only. They break away easily.
No need to make the print super strong but since it is so small you can do four walls because why not.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
