Thingiverse
BIQU Microprobe adapter
door ericsm123
16
Downloads
12
Likes
1
Makes
This is a simple adapter so that the Biqu Microprobe can be mounted on the mounting points made for a CR Touch or a BL Touch. It is essentially an extender, since the microprobe is significantly smaller in height than the usual suspects.
Printed in PLA, 15% infill, 5 walls/top/bottom.
You would need two M3x20mm for mounting.
Printed in PLA, 15% infill, 5 walls/top/bottom.
You would need two M3x20mm for mounting.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!