BIQU SE-PLUS H2 Conversion

This will allow you to convert your BIQU SE-PLUS so that it uses the H2 extruder. You will need to remove the breakout board on the tool head and replace the ribbon cable with the cable harness that comes with the H2 unit. You will then need to wire it directly into the motherboard within the machine.The exact wiring locations should be easily discernible by looking at the markings on the motherboard where existing wires connect.

The base plate requires three M3 heated inserts to secure it to the SE-Plus carriage. I use ones that I got in a kit from banggood and they work well. If yours are slightly different then you can adjust the step file provided.