BIQU Terminator Hot End Mount

#BIQU Terminator Hot End Mount#
This is a mount solution to put the biqu terminator extruder on a folgertech ft5 r2 (may work on original?). This setup also works for an EBB36 CAN bus board from BIQU which I used but I suppose you could ignore that mount and proceed as you wish. There are also 2 brackets to adjust the offset of the x gantry belts so that this carriage connects nicely. This is a work in progress technically but it is a currently functional work in progress. This carriage may work on other machines that have an x gantry like this, the folgertech isn't anything special in this regard. As noted in the print settings, I finished this project by printing the carriage with nylon for high-temperature resistance. The motor mount and idler plates were just printed in PLA and seem to work great. This mod also reduces the X by about 20mm and the Y less than 10. I may re-work the design to improve this but my original goal was just to get it all working.

##Some story##
I origi