Thingiverse
Bird Feeder
von Hartvik
92
Downloads
81
Likes
1
Makes
Droplet-inspired bird feeder.
No support is needed! Use 15mm brim to ensure the model is stable during print
Tie a knot on a rope to hang it on a branch. Use a stick for the bird stand.
Fasten with a hot-glue gun.
I used clear coat lacquer on the outside so it is a bit more waterproof.
No support is needed! Use 15mm brim to ensure the model is stable during print
Tie a knot on a rope to hang it on a branch. Use a stick for the bird stand.
Fasten with a hot-glue gun.
I used clear coat lacquer on the outside so it is a bit more waterproof.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!