Thingiverse
Bird feeder
by Azgard_7487
44
Downloads
68
Likes
0
Makes
This bird feeder has flat back side on that I put duct tape on and then attached to the window.
The food for the birds is crushed raw sunflower seeds. There are no supports inside the feeder because I made the front shelf inclined 49 degrees.
The supports are only at the final stage, they are needed for printing the stick for the birds' feet.
The food for the birds is crushed raw sunflower seeds. There are no supports inside the feeder because I made the front shelf inclined 49 degrees.
The supports are only at the final stage, they are needed for printing the stick for the birds' feet.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
